Using My Moulds

All of my moulds are made from high quality silicone. They may be used with resin (https://amzn.to/3WiYcG0), plaster of Paris, Herculite (https://amzn.to/4bcnY32), concrete and (they are food safe) jelly and chocolate.

These moulds will be good for many castings if you look after them. Always use a mould release spray (https://amzn.to/4bgaQKs) and remove casting from mould slowly and carefully.

Resin is a versatile material that can be poured into moulds to create a wide variety of items. The process of using resin with moulds requires a little pratice and patience, but the results can be stunning.

First and foremost, it is important to choose good quality resin. It is essential to read the instructions on the resin packaging carefully to ensure that you are using it correctly.

Before you begin pouring the resin into the mould, it is important to prepare your work area. Ensure that your workspace is clean, well-ventilated, and free of dust and debris. It is also a good idea to wear gloves as resin can be difficult to remove from hands. Some people wear a mask, to protect from the resin fumes.

When mixing the resin, be sure to follow the instructions carefully. Resin is typically mixed in a 1:1 ratio of resin to hardener, but this may vary depending on the brand and type of resin you are using. Mix the resin and hardener thoroughly but gently to avoid creating air bubbles in the mixture.  I find that mixing by weight is quicker if the brand of resin allows that. Add colouring if you wish.

Once the resin is mixed, spray the mould with mould release agent and then carefully pour it into the mould. Use a toothpick or a skewer to remove any air bubbles that may have formed. It is also important to prevent the resin from overflowing the mould by pouring it slowly and in small batches if necessary.

After pouring the resin, allow it to cure according to the manufacturer's instructions. This may take anywhere from a few hours to a few days, depending on the type of resin you are using. Once the resin is fully cured, carefully remove the finished piece from the mould.

There are lots of helpful videos on Youtube if you run into problems. 

My large plaques are about 18mm thick but you can make them thinner depending on the use.

When I sell coasters/fridge magnets I ask the customer what they are going to use them for and give them either self-adhesive pads (https://amzn.to/3WeqXDX) or self-adhesive magnets (https://amzn.to/3w3rtKp).


Where To Sell Online In The UK

https://www.amazon.co.uk/handmade
https://www.bristolmarket.co.uk/
https://craftersmarket.uk/
http://etsy.com/
https://folksy.com/
https://www.notonthehighstreet.com/
https://www.numonday.com/
https://thebritishcrafthouse.co.uk/
www.mademe.co.uk
www.madebymums.co
www.handmadeinbritain.co.uk
www.supportthemaker.com
www.buyindie.co.uk
www.mycraftshop.uk